Gadgets Manual

You can break the tabs on your GoPano case if you are not careful. Please follow these 3 steps below to opening your GoPano optic the correct way.

PUT ON FLAT SURFACE
Please place your GoPano case on a flat surface like a table. Press the GoPano against the table with one hand grabbing the end where the red plastic dust plug is. With your other hand lift up the tab on the end. Then move your hand up the case to the top tab and lift the tab up while trying to lift the case up with your hand holding the back of the case.

Viola! Your case will open. Because the case and tabs are freshly vacuum formed plastic, opening up the case will get easier with more frequent openings. Never pull too hard on the tabs as they will break.

SET THE FOCUS TO MACRO
(A) See the close up flower icon?
Press this until you see the Flower
Icon on the back of your camera. This sets the camera to focus on the mirror.
Turn VR OFF.
VR (Vibration Reduction) is a feature available on a lot of cameras but is incompatible with the GoPano optic.
FLASH. Turn OFF.
You will see a circle icon with a LIGHTNING bolt in the center.
Turn DIAL to M for Manual.
F-Stop for Point & Shoot Cameras Use an F-stop between F6.1 and F7.4
F-Stop for SLR Cameras
Use an F-stop of F22 or higher. Choose Close Up or Macro Mode If your point and shoot camera has a Macro close up mode (Flower or Face icon), use it to focus on the mirror.

Get pdf GoPano 360° Optic Quick Start Guide