Gadgets Manual

This FAQ is applied to the below models and operation systems: PS-1203 / PS-1205 Windows 2000/XP only
Introduction: This installation guide is for walking you through the configuration of Edimax Printer Server as shown in the Figure-1. No software is required for sharing printers in this way.
Step by step:
Step one : Change the default IP of Edimax print server from
10.0.0.1 to fit within the IP ranges of your office LAN.
(1). Shut down both the Edimax print server and the PC used to configure the printer server. Power on the print server before booting up the PC.
(2). Connect the PC to the print server like Figure-2.
(3). Assign IP, 10.0.0.2 to the PC.
(4). Assign another IP address of print server to meet your office LAN requirement as shown in the Figure-3. (Here we assign 192.198.2.22 to the print server. Please give proper IP address to your Printer server based on your office networking requirement.)
Step two : Connect the Print server to your office LAN
Note : At this stage, all the PCs in your LAN are able to communicate with the print server. Please set up your PC back to be within your office IP ranges, 192.168.2.20 for example or obtain the IP from the DHCP, if any.
Step three : Easy configurations in the PCs for using the printers shared by Edimax print server.
(1). Install the printer driver. (Please refer to the printer manual. In this guide, we assume that you have installed the printer driver, HP LaserJet 1100) (2). Use Windows build-in wizard to add the print port using the IP, 192.168.2.22 of Printer Server.

Get PDF