Gadgets Manual

RSS Feed

Free Ebooks Download

HP NetServer E 800 Installation Guide

October 21st, 2008 · No Comments

This installation guide is a quick reference for HP NetServer E 800 installation. Skip any steps that do not apply to your installation. Refer to the figures below for connection and operating information. For more information, refer to the HP NetServer E 800 User Guide.

Step 1: Attaching all the Cables
If you are not installing any accessories, attach all available cables to the respective connectors, then go to “Step 7: Configuring the HP NetServer.”
NOTE
The two USB connectors are reserved for printers, scanners, and external modems. The NetServer does not support USB connections for the keyboard and mouse.

Step 2: Opening the HP NetServer
Tools Required:
• ¼ inch flat-blade screwdriver
• Torx T-15 driver
WARNING
Before removing the cover, always disconnect the power cord and remove the telephone cable.
Disconnect the power cord to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects such as tools or jewelry. Disconnect telephone cables to avoid exposure to shock hazard from telephone ringing voltages.

Step 3: Installing Memory
• Use only HP DIMMs, which are 3.3V, 168-pin, PC133 (133 MHz), buffered SDRAM DIMMs in 128 MB, 256 MB, or 512 MB.
• DIMMs may be installed in any slot, in any combination (sizes mixed), in any order, but HP recommends starting at slot 0 and filling the slots in order with the largest size first: 0, 1, 2, and 3.
• Ensure both latches close on the DIMM when completely installed.

Get pdf HP NetServer E 800 Installation Guide

Related Manual


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

Leave a Comment

eXTReMe Tracker