Gadgets Manual

SprintScan 35 Quick Scanning Guide iii 1 Introduction Macintosh system requirements 1-2 PC system requirements 1-3 Technical Support 1-4 Registration card 1-4 Unpacking 1-5 2 Setup and use The scanner 2-1 Positioning the scanner 2-3 SCSI guidelines 2-4 SCSI ID numbers 2-6 Installing a SCSI adapter in a PC 2-7 Connecting the scanner to your computer 2-7 Diagrams of various SCSI configurations 2-8 Turning on the scanner 2-10 Inserting originals for scanning 2-11 3 Care and maintenance Maintenance 3-1 Changing the lamp 3-2 Changing the fuse (ES scanner only) 3-4 Troubleshooting 3-6 SprintScan 35 warranty 3-8 SprintScan 35 service 3-8 Polaroid Offices and Service Centers 3-9 Radio and television interference (LE and Plus) 3-11 Radio and television interference (ES) 3-12 Appendix A: Specifications A-1 Index I-1 Use this as a quick reference for scanning. For details, see the pages indicated. See page: 1-5 1 Unpack the SprintScan 35 scanner package. 2-7 2 Install a SCSI host adapter card in your computer (PC-compatibles only). 2-6 3 Change the SCSI ID number of the scanner, if necessary.

The scanners are factory set to SCSI ID number 6. 2-7 4 With all equipment turned off, connect the scanner to your computer using the SCSI cable provided. If the scanner is the last device in the chain, use a terminator at the scanner (LE and ES scanners) or move the termination switch to ON (Plus scanner). 2-10 5 Plug the power cable into the scanner and into a grounded power outlet. 2-10 6 Turn on the scanner, then your computer. 7 Install the software according to the software manual. 2-11 8 To scan an image, insert an original into the scanner. 9 Initiate the scan from the software (see the software manual). Warning: Please follow the detailed instructions in chapter 2, Setup and use for connecting the equipment. Improper connection could damage your computer, the scanner, or both.

Download SprintScan 35 User Guide Manual