Gadgets Manual

Step 1 - Display Assembly The iPad shown in the photos may look slightly different from your iPad, but the procedure is the same. Insert a metal spudger between the right edge of the display assembly and the rear panel assembly. Rotate the spudger away from you to release the tabs along the top edge […]

[Read more →]

Tools used in this guide - Phillips #00 Screwdriver - iPod Opening Tools
Step 1 - Rear Panel - Before disassembling your iPhone, be sure the silent switch is activated
Step 2 - Remove the two Phillips screws next to the dock connector.
Step 3 - Push the rear panel toward the top edge of the iPhone. The […]

[Read more →]

Step 1 - Rear Panel Before disassembling your iPhone, be sure the silent switch is activated.
Step 2 - Remove the two Phillips screws next to the dock connector.
Step 3 - Push the rear panel toward the top edge of the iPhone. The panel will move about 2 mm.
Step 4 - Remove the rear panel from […]

[Read more →]

Step 1 - Battery
Remove the two Phillips #00 screws from the dock-connector end of the iPhone.
Step 2
There is a rubber gasket between the silver front bezel and black display assembly. A bit of force is required in this step to separate the iPhone’s display assembly. Use a small suction cup near the Home button to […]

[Read more →]

Step 1 - Battery
Remove the two Phillips #00 screws from the dock-connector end of the iPhone.
Step 2
There is a rubber gasket between the silver front bezel and black display assembly. A bit of force is required in this step to separate the iPhone’s display assembly. Use a small suction cup near the Home button to […]

[Read more →]

Step 1 - Battery
Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer.
Step 2 - RAM Shield
Remove the three identical Phillips screws from the memory door.
Step 3 - Lift the memory door up enough to get a grip on it, and slide it toward […]

[Read more →]

This installation guide is a quick reference for HP NetServer E 800 installation. Skip any steps that do not apply to your installation. Refer to the figures below for connection and operating information. For more information, refer to the HP NetServer E 800 User Guide.

[Read more →]

Setting Up Your MacBook Pro
Your MacBook Pro is designed so that you can set it up quickly and start using it right away.The following pages take you through the setup process, including these tasks:
- Plugging in the power adapter
- Connecting the cables
- Turning on your MacBook Pro
- Configuring a user account and other settings using […]

[Read more →]

Connecting your handheld device with iBT-GPS. Please refer to the user manual of PDA to enable the Bluetooth. connectivity. If the connection between..iBT-GPS Solar Bluetooth GPS Data Logger User’s Manual Published on 8-Feb-2007 Rev 1.1 8029504601A2

[Read more →]

Connecting your handheld device with iBT-GPS. Please refer to the user manual of PDA to enable the Bluetooth. connectivity. If the connection between. iBT-GPS Bluetooth GPS Receiver User’s Manual Published on 25-Jan-2007 8029407601C2

[Read more →]