Power Craft products are manufactured to high quality standards and they are safe and fit for purpose at the time of sale, but all tools and machines can be dangerous if the correct precautions are not taken. Arc welders provide a simple and portable solution for many welding requirements. They are safe if used with care, always follow these instructions, do not carry out the operation until you are sure you can do so in safety. Remember to consider the working environment for safe operation in addition to the safe operation of the machine.
Cleaning & maintenance
Check for damaged parts
Do not use the welder with damaged parts, before further use a damaged welder must be carefully checked by a qualified person to determine that it will operate properly. Check for breakage of parts, mountings and other conditions that may affect its operation. An authorised service centre should properly repair a damaged part. Have your welder repaired by an expert
This appliance is manufactured in accordance with relevant safety standards. Only experts must carry out repairing of electrical appliances, otherwise considerable danger for the user may result. Use only genuine replacement parts, which are available from the Helpline
Do not use modified or non-genuine parts
Replacing welding cables
BEFORE MAKING THE FOLLOWING CONNECTIONS MAKE SURE THE WELDING MACHINE IS SWITCHED OFF AND DISCONNECTED FROM THE POWER SUPPLY OUTLET.
It is strongly recommended that genuine replacement cables be used. These are available from the helpline.
Storing the Welder
When not in use the welder should be stored in the dry, out of reach of children and in a frost-free environment.
Ensure the items are disconnected from the electrical supply and cannot operate accidentally when, servicing or cleaning.
The machine does not require any special maintenance; however the user must be aware of the following:
• Regularly clean the ventilation slots.
• Keep the casing clean.
• Check all cables before use.
• Check electrode holders and earth clamps before use.
• Replace worn electrode holders and earth clamps, which do not provide a good connection
Get pdf Turbo Fan Cooled ARC Welder 40 -160 AMPS User Guide